Activity Stream

I have a 91. I changed my SADS, using the BMW coupler upgrade. Lots of posts on how to do that here. The later ones use a different shaft, it's...

Try megazip. They seem to have some engine mounts anyway, but they don't always have what they seem to have so email them first.

In Barrington IL, probably Toyota or perhaps a foreign auto repair shop. Or try this thread for some insight ...

Yoshiparts does not have the mounts. They didn't have the rear hatch handle either. What a bummer.

eh, crap. Can't even test this 93 because the pulley is frozen. Oh well I can test the 97 and try swapping parts if needed, and if they fit. I will...

If you hear the pump near the tank and/or can hear the fuel flowing in the engine area, then it's working. FYI, The Circuit Opening Relay only sends...

i wouldn't let anyone at my Oreilly's test anything electrical, they know nothing. But I just got back from another parts store where there are...

Hey Tim so my van’s not starting, and I can only hear the fuel pump when I do the jump connector never when I just put my car to on. It sounds like...

It is a 30 year old vehicle, in my opinion it is better to get comfortable doing some mechanical maintenance yourself. ...

Just about any auto parts store (NAPA, Auto Zone, O'Reilly's, etc.) can bench test your alternator

Got the brushes, regulator and diode assembly out, and what do you know...there they are. The brushes look good, I don't think I can test the...

Got her out with the crow end of a crow bar, prying against the PS pump

This is my parts van so the battery is long gone. I just want to get inside and see what there is to see to prepare myself for possibly doing the...

I remove the battery for better access to the alternator. A gentle pry and/or a few taps on a block of wood on the case should free it up. The...

I just might try this, doesn’t sound too difficult thank you! I’m also seeing a 2014 Toyota Corolla hose isn’t too far off either! I may do some more...

Check my thread right below yours "Crank no Start fuel issue- 1986 LE 2WD Auto" In the third post i was having a similar issue due to a cracked...

Update, there is spark just tested it. I also found the fuse 1 (7.5 ign) was missing so I threw the one of the spare fuses in that spot and the van...

That’s what I did as well. I used 15mm copper pipe, but if you have 5/8 inch that would probably be even better, i used soldered T fittings where...

That intake hose is a nice find! Still a little cheaper than cobbling one together with silicone pieces, especially if you want the flexible middle...

I cleaned mine up really well, and soaked them in AT-205 Re-seal to restore pliability to the rubber. I seem to not have taken any pics, but it does...