Activity Stream

:drool: Oh i love it, if only I didn’t live on the other side of the globe, and my girlfriend wouldn’t kill me if I put another vehicle (or project...

I only have experience with one van, mine, a 86LE but mine has/had that 3-wire alternator control cable, and mine could simply unplug on both ends,...

Good news. That's a job I never want to do myself.

Another update: Previa still running strong at 50K miles after head gasket replacement. Finally retired it as daily driver but use it when hauling...

It seems to me that the clutch on the previa would be a good bet. Pressure plates, however, seem unlikely to overlap as much, as they are attached...

Interestingly, the "maintanence note" book had some pages torn out that would have perhaps identified the original owner. There were no records, but...

Reviving this thread, hoping to get more info and photos of how and where to mount the "base plate" on a Van Wagon that a towbar would attach to. I...

Lowering price to $6,499!

Still selling this beaut?

This should get you through the diagnostic codes. https://www.toyotavantech.com/forum/content.php?196-Engine-Service-Connector

had it checked now, thanks! Everything was ok.

Ya checking the list of possible issues off the list is very satisfying. Today I ordered the OEM repair manual and wiring diagram booklet as...

Loose negative terminal caused incorrect codes to be generated. After tightening, it read codes P0300, 301-304 and 125. Spark plugs or/or ignition...

Those wires look a lot happier now and while it didn't solve your issue, at least you have eliminated one variable. I forgot to ask previously,...

So I took fuel pump/fuel sensor harness off the Van and tested each wire and connector with a meter. Everything checked out. Got those babies lookin...

Hey Burntboot. So apparently the wires were not severed but are in a bad way. I think I should cut them, solder them and shrink wrap them. I’d...

And given that it tries to run, it sounds like spark isnt the problem, stay with the fuel system until you can rule it out.

Good news that its clean inside. Those wires need to be fixed properly before you put the tank back in (solder and shrink). I would also...

Burntboot! Thank you responding. Other than fluid services and details I’m a very novice mechanic so having someone to bounce ideas off of is a...