Activity Stream

Try putting it in reverse and see if the reverse lights get brighter. If they do, then you likely have an issue with your taillight ground.

Hmmm very niiice!! JDM

Do you have a trailer connector with reverse lights? Then maybe the two wires touch.

I would kill for a wiring diagram to help you, but my best guess is: If it is not in reverse, but they only come on when you turn on the running...

Wow!. When I had the engine overhauled and removed the FPD they used two of the 20810's on both top and bottom. So this 12005 goes on top against...

Can you tell what side it's leaking from (fuel rail side or FPD side)? If it's leaking from the fuel rail side, then yeah, it could be a blemish on...

Tim, one more thing. you sent me two washers to use a 23232-28010 and a 90430-12005. The damper uses two 28010's, one on top and one on the bottom....

Thanks Tim. I replaced Fuel Damper about 30K ago. Like I said, it did the same thing then. But some additional tightening it stopped. Do you think...

"so I am getting a click on my ac relay, no power to my ac fuse and and strange reading on the power right before my blower motor (42 volts?!) this...

Check very closely to be sure it's coming from a washer surface. Then take it back apart and check the mating surfaces. If there's a problem, you may...

Hey Tim: Got my new washers for the damper but found after installatioin a tiny fuel leak on the top side of the banjo fitting. It is very small...

A 42V reading from a 12V system would indicate either a problem with the meter or the way it is being used.

Anybody got any suggestions as to what this might be?