Activity Stream

Thank you, it's interesting. A mechanic also told me that it could come from the Hall effect sensor in the ignition system. It's strange. I don't...

What is your timeline for needing it gone? Also, do you mean we just need to pick up (or ship) the whole van? Or is it already in pieces? Sorry; new...

Sorry, i have no specific experience with this engine, but in general, if there is a spark, but not a good one, you already checked the most logical...

ok, Thanks Tim, I bought it because it was stated compatible by another vendor. I'll order the correct part. Tranny had lost 1 qrt of oil due to...

there is a manual floating around the site, you may have to wait till the link to the google drive resurfaces. then you can download and save. I...

If you're talking about the Beck-Arnley #052-3382 I mentioned above, that's the one used for automatic transmissions (not compatible with a manual...

Ordered this part, says it's incompatible with the output shaft. Which side faces outward that I'll use to tap into the tranny? It seems wider than...

Have any luck finding one? Mine is currently held together with glue and electrical tape. Just browsing the forums to see what I can find or if...

Thank you! I just fixed them all. This helps as I don't have a lot of time to scan the forum. It's easy to fix though, so if you find more please let...

Ok, that makes sense. Thanks Tim Here's one more post several of the old links: ...

Thanks for pointing that out. I just fixed all those links (including the one in your post above : ). FYI a few years ago our hosting company...

Hi all. Seems an appropriate place for this question. I have this very thing happening, and I'm betting the vent at the top of the transmission...

Thought I might tack onto this since I just replaced my whole exhaust last year. My van had a horrid exhaust on it, the flex pipe was severed off...

Ah life has been so busy these past months, now I finally have some time to kill and some wheel cylinders to rebuild! Cant remember which cylinder...

Replying to what Burntboot meant, heres a proper thread for the steering wheel removal:...

Sounds easy enough! Thank you for the advice

The horn pad is held on with screws from the back side Mark the position of the wheel to the shaft Remove nut, install puller, pull wheel If you...

Sometimes if you live where there are winters with salted roads and your exhaust system has not been touched in years, you end up with rusted "lumps"...

Ah yes, I just discovered that too. The length of the pulley shaft seems to be different, so the backside of the Toyota pulley would also need to be...

I have not finished installing it, but i had the exact same issue, I got a Wai 13982n alternator. I also could not find a denso from a source I...

Following up on this as well. Since Denso 210-0461 seems unattainable at the moment, I went with a Bosch AL4507X which is supposed to be the same...