Activity Stream

No longer available Description: Toyota Vanwagon bracket,engine/transmission mounting, rear Part number: 12303-54010 Alternate Part...

Thanks John. This looks right and the picture is very helpful. Now I can tell what I am getting into. I didn't know about ToyoDIY.com. It's a...

I think the part number is right, but the picture is misleading; it appears to show one of the two studs for the face flange. (Maybe the studs come...

Gaskets are easy to make. O-rings are easy to find.

Does anyone know the part number or part description for the gasket that goes between the head and the oil return pipe. This is the pipe that drains...

If the starter is shorted internally, it would show as having continuity between the positive connection and the housing, same for the solenoid. If...

the remote start was basically just looped between original starter/ ignition wire. as in it connected to small black wire to starter i referred to,...

As I am working from memory and also suffer from CRS, take everything with a grain of salt I dont believe I have ever met a starter that had...

No idea on "under chamber" if I were the guessing sort, I might head to the intake plenum, to the bundle of wires that connect to ground there. My...

so nobody knows where ground point E ....FSM " located on under chamber " is?

Yeah, I can't use a scangage at all due to a lack of OBD2. Its a 94, after all. I'm fairly certain the scan tool I have, while it can read Toyota...

If not a scangage, just do it the old-fashioned way (except of course that you're looking at the timing pulley from below); clip the sync line onto...

Can use a scangage ii. There is a timing setting that changes realtime with driving

How would I check the timing? With the engine placement I'm not sure where I'd use a timing light. With the JDM ECU, I don't think my code reader...

SOLID BLACK WIRE i meant

I just unplugged the pump that is located on the bottom of the oil reservoir under the hood. It is bad to overfill an engine with oil. I unplugged...

Check the timing, esp with acceleration. Some of the sc engines were overly sensitive to knock sensor signal, which would retard the timing with...

Thanks Man_btc... I appreciate your reply and now won't worry so much. I also just read a thread about checking valve clearances and my need to do...

1992 Previa owner here. I don't think there's anything on the Previa with such catastrophic failure potential that's as hidden away from examination...

I have a 1991 Toyota Previa. Is there a hose of death or other "disaster looming" issue on a Previa like this Hose of Death? I've read this...

I'm appending this onto an old thread as it might be useful for more valve-adjustment info in one place. While doing something else, I just ran...