Activity Stream

Still selling this beaut?

This should get you through the diagnostic codes. https://www.toyotavantech.com/forum/content.php?196-Engine-Service-Connector

had it checked now, thanks! Everything was ok.

Ya checking the list of possible issues off the list is very satisfying. Today I ordered the OEM repair manual and wiring diagram booklet as...

Loose negative terminal caused incorrect codes to be generated. After tightening, it read codes P0300, 301-304 and 125. Spark plugs or/or ignition...

Those wires look a lot happier now and while it didn't solve your issue, at least you have eliminated one variable. I forgot to ask previously,...

So I took fuel pump/fuel sensor harness off the Van and tested each wire and connector with a meter. Everything checked out. Got those babies lookin...

Hey Burntboot. So apparently the wires were not severed but are in a bad way. I think I should cut them, solder them and shrink wrap them. I’d...

And given that it tries to run, it sounds like spark isnt the problem, stay with the fuel system until you can rule it out.

Good news that its clean inside. Those wires need to be fixed properly before you put the tank back in (solder and shrink). I would also...

Burntboot! Thank you responding. Other than fluid services and details I’m a very novice mechanic so having someone to bounce ideas off of is a...

Just a small update to this thread - after some months off the road and a visit with a very friendly local family-run performance shop, we found that...

No durability problems to relay. MPG subjectively slightly better overall. Lower temps. If I did it again I'd adjust my timing exactly the same. That...

If you drop the tank , you should also check the two brake lines that run above the tank. I did not change mine the first time I dropped the tank,...

I hope it's not too cold to take some photographs of your work to post on this thread! Then you will be thanked in the future. Työ tekijäänsä neuvoo...

Welcome to the party. I dont know anything about 1st Gen's but as no one has responded yet ... It should be easy enough to check for spark, once...