View Full Version : SADS ON THE HOIST
Davetarago
02-09-2014, 11:08 PM
Hi thanks for accepting me.
My sads have chewed right out and the mechanic doesnt know which way the new ones go in.
Where can I find help quick?
timsrv
02-09-2014, 11:48 PM
Hi & welcome to TVT! Here's a service bulletin (attached pdf) that gives very specific directions on assembling:
Davetarago
02-09-2014, 11:50 PM
Hi
Thanks very much for that, I'll shoot it straight off to him.
:)
TheMAN
02-10-2014, 05:41 AM
you have a 99 tarago? so in that case, make sure you buy the couplings kit from toyota, not anywhere else... the toyota couplings are the best and only works for 94-99 taragos
Davetarago
02-10-2014, 05:49 AM
Hi
thanks for replying to the thread. I will take your comment on board.
studio65
04-29-2014, 09:12 AM
What do you guys think of this solution found on ebay.
http://www.ebay.ca/itm/Drive-Shaft-Reman-Driveshaft-Prop-Shaft-Front-Cardone-fits-91-97-Toyota-Previa-/300987714812?pt=Motors_Car_Truck_Parts_Accessories&fits=Make%3AToyota%7CModel%3APrevia&hash=item4614440cfc&vxp=mtr
timsrv
04-29-2014, 09:56 AM
I'm thinking it's the aftermarket flex couplers installed on a used shaft. It could be either shaft, but I'm guessing it's a 91 - 93 (more of those out there for cores). You'd probably be better off to finding a used 94 & up shaft, then purchasing new couplers from Toyota. Tim
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.