nobrush
11-26-2022, 07:46 PM
Hey all,
Does anyone have a diagram or photos of the physical locations of the grounds as opposed to just the electrical locations in the schematic?
I've mentioned I have an issue with my ISC not getting the voltage signal from the computer to the RSO pin. I'm wondering if it's a bad ground issue due to the voltage reading I'm getting for only a second initially which is lower than I'm guessing it should be after troubleshooting it.
I just found the one from the engine block to the coil, then to the frame and I'm thinking I should go thru all of them and clean 'em.
Does anyone have a diagram or photos of the physical locations of the grounds as opposed to just the electrical locations in the schematic?
I've mentioned I have an issue with my ISC not getting the voltage signal from the computer to the RSO pin. I'm wondering if it's a bad ground issue due to the voltage reading I'm getting for only a second initially which is lower than I'm guessing it should be after troubleshooting it.
I just found the one from the engine block to the coil, then to the frame and I'm thinking I should go thru all of them and clean 'em.