• radtekmr

    There is no available content written by radtekmr
  • Recent Article Comments Widget

  • Recent Blog Posts

  • Recent Forum Posts

    MyToy

    Re: Charging Air Conditioning System

    Oh, never even went there!

    OK, I have a set of generic O rings of all walks of life. Just wondered if the freon would react funny with them.

    But great idea Tim.

    Will keep you posted

    MT

    MyToy 05-26-2020, 10:33 AM Go to last post
    Mtn_Van

    Re: The Fan Clutch (clutch fan / fluid coupling) Thread

    For anyone that needs to remove/install the fan clutch for whatever reason, the extra long 10mm 12-point box wrench I picked up works wonders. No more worrying about rounding the four fan nuts if...

    Mtn_Van 05-25-2020, 08:37 PM Go to last post
    timsrv

    Re: Charging Air Conditioning System

    I checked all over for those too and found nothing. You can use round o-rings here, as long as the diameter of the rubber is correct and the overall length is right for the groove. The real advantage...

    timsrv 05-25-2020, 04:50 AM Go to last post
    MyToy

    Re: Charging Air Conditioning System

    OK, I will give that a whirl. I did check the plates on glass and 200 grit emery. They look flat with no high marks.

    I did look at the o rings a bit , but not that detailed for sure. What I did...

    MyToy 05-25-2020, 04:02 AM Go to last post
    vanboi420

    Re: Engine noise, potential knock. Replacement motor suggestions?

    Thank you for the clarification on the engine. The spark plugs were replaced correctly by one mechanic but the the knocking noise still persists even after.

    vanboi420 05-25-2020, 03:21 AM Go to last post