thanks for your response to my post. you mention in the last line that i may have leaks at the hose connector from the reservoir - as i do have a small leak showing on the floor mat beneath the...
Type: Posts; User: oldvanguy; Keyword(s):
thanks for your response to my post. you mention in the last line that i may have leaks at the hose connector from the reservoir - as i do have a small leak showing on the floor mat beneath the...
i have a slow leak in my hydraulic brake and/or clutch system. is does not (yet) affect braking or gear selecting/changing. is there any chance that it's just the plastic reservoir leaking? the leak...
hi,
i'm in need of passenger side (P/S) power window regulator for '86-'89 toyota van. not the motor but the skeletal assembly that holds and guides the window up and down.
i know this post is...
i need a passenger side power window regulator (not the motor - just the skeletal part/assembly that holds and guides the window). might it still be available?
thanks for any response
re: my previous post: new plan!
given that the only thing not working on the master control panel is the D/S window switch, instead of replacing the entire master control, i now want to simply...
this thread is excellent! having gone through all the D/S master control possibilities listed (disassembly, cleaning contacts and reassembly), i got everything working except the D/S window (which...
parts were pulled during an overhaul in search of piston slap noise. noise never found. engine had approx 160k miles when overhaul was done in march, 1997...
Re: Published on 09-30-2018 01:52 PM Number of Views: 87
Adjusting and changing door hinges
1st generation (1984-1985) van
hello,
is this also the same procedure for a second gen '87 4WD...
hi, i'm looking for a pair of serviceable (tight, no up/down movement when door is open) left or right door hinges.
thanks for any response
hi, am looking for serviceable (tight, no up/down movement of door when open) front door hinges (left or right side) top and bottom.
thanks for any reply
hello, i am looking for front door hinges (upper and lower) for my '87 4wd LE
just to let everyone know of how it turned out for me: front left upper control arm bushing grease point: accessing it from the wheel well with the wheel off. first, tie off or disconnect and tuck...
the ball joint is right behind the front wheel on each side. the access caps on the passenger side control arm bushings are a bit more problematic. one is at the very front of each arm and can be...
"On the 4wd there are also grease points on the upper control arm bushings (so don't miss those)". per Tim
what is the trick to getting at the passenger side, front, upper-arm bushing grease...
i ran castrol syntec 20w50 for approximately 100,000 with no issues. last oil change (5k ago), i switched to 5w50 castrol full synthetic. it's a little spendy @$9.67/quart, but i am a synthetic...
found that part #: 90430-27001
mr Burntboot: any idea about where to get the oil level sensor gasket(s)? do you have a part # perhaps? thanks.
thanks Burntboot. so the the oil level sensor is removed from the exterior of the pan?
thanks for your response. i will proceed with the replacement.
just wondering if anyone has had to replace the oil pan on their van because of rust? my tech says it could rupture causing total loss of oil and quick destruction of motor. he said it is common on...
my '87 4wd le van (which i've owned for 20 years) was converted to R-134 two years ago. A/C has not worked for at least one year. today i had A/C serviced and recharged (it had .31 lbs. in system)....
in burnboot's reply to an old post about converting A/C to R-134 it mentioned that the compressor should be removed and drained of oil as it was incompatible w/ the R-12 oil. two years ago in...