Search:

Type: Posts; User: apham8; Keyword(s):

Search: Search took 0.02 seconds.

  1. Re: Yahoo Previa Group Files available until 12/14/2019

    Do whatever works best for you, if we have to directly contact for the link then that’s what we’ll have to do.
  2. Re: Yahoo Previa Group Files now available in easlily readable form

    Thanks for following through on making this information accessible! I’m sure the information will be indispensable.
  3. Replies
    8
    Views
    5,548

    Re: need some help from you professor Tim

    Ok, thanks for the confirmation timsrv. The previous owner of this Previa took really good care of it. Replaced the SADS in 2010 and even replaced motor with low mileage JDM engine at 393,xxx miles...
  4. Replies
    8
    Views
    5,548

    Re: need some help from you professor Tim

    This link is no longer active, but the link states the Part number being 37910-28050, which I am assuming is the equivalent of the 94-97 Previa's factory installed SADS shaft?

    I recently purchased...
  5. Replies
    10
    Views
    7,711

    Re: seat cushion transplant

    After looking at the picture closer, is the rail attached to the hinge where the backrest pivots? Which means that if you remove all 4 bolts the seat bottom cushion chassis would separate from the...
  6. Replies
    10
    Views
    7,711

    Re: seat cushion transplant

    The ‘95 does not look familiar to me, must be a slight design change. The 1991-1993 Seat bottom cushion chassis always came loose when removing the 4 corner bolts. I couldn’t be much help outside of...
  7. Replies
    10
    Views
    7,711

    Re: seat cushion transplant

    I think the ‘95 seats are different design, which I do not have experience with. The ‘95 seat frame may be same? Not sure.

    But the 12 mm bolts are in the corners of the metal frame that the foam...
  8. Replies
    10
    Views
    7,711

    Re: seat cushion transplant

    For the 1991-1993 there's four 12 mm bolts that hold the metal chassis that the foam sits inside of. It's very easy to see the four bolts once the seat is out and you can look underneath. These metal...
  9. Replies
    6
    Views
    7,250

    Re: Looking for front coil springs

    I bought some KYB front coil springs for my 1992 Previa LE 2WD off of eBay. It was about $150 shipped from the UK. Although, since then I think the prices have gone up.

    The model numbers: KYB...
  10. Thread: Seatbelt

    by apham8
    Replies
    3
    Views
    4,702

    Re: Seatbelt

    There are various refurbishing companies that will replace the seat belt material for approximately $75.00. I plan to do this soon, but did find a driver's seat belt from a 1995 Previa for my 1992...
  11. Replies
    33
    Views
    51,009

    Re: Help locating the starter relay

    Thanks for the reply, I have the old Denso starter and opened it up today. The contactors were definitely worn down. I will buy the contactors from Toyota and get it rebuilt as a back up unit since...
  12. Replies
    33
    Views
    51,009

    Re: Help locating the starter relay

    Has been starting every time since the Denso reman starter was installed. I was curious about my starter issue and looked up to see if anyone else had the same issues.

    For future reference, this...
  13. Replies
    33
    Views
    51,009

    Re: Help locating the starter relay

    The Denso Starter came in yesterday and was installed. The problem has non-start issue has yet to return, but it's been less than a day. I will say that the sound of the starter is noticeably...
  14. Replies
    33
    Views
    51,009

    Re: Help locating the starter relay

    Very well may be the ignition switch. I ordered a Standard Motor Products ignition switch, but it got sent to the wrong address! So I just grabbed one off a 1993 Previa at the salvage yard. Needless...
  15. Replies
    33
    Views
    51,009

    Re: Help locating the starter relay

    Thanks for the insightful pieces of obscure information regarding the 1992 Previa's lack of a starter relay.

    My issue has been an intermittent starting issue. I sometimes will, more often...
  16. Replies
    33
    Views
    51,009

    Re: Help locating the starter relay

    Very interesting, so the ignition switch goes directly to the solenoid on the starter?
  17. Replies
    33
    Views
    51,009

    Re: Help locating the starter relay

    10645

    I was at the local Pull-A-Part and there was a 1992 Toyota Previa. That is the location to the right, behind the instrument cluster.

    This is precisely what my 1992 Previa looks like in...
  18. Replies
    33
    Views
    51,009

    Re: Help locating the starter relay

    The socket is missing, so it is not any empty socket. Simply not in that location. So unbelievably odd because the Factory Service Manual states that it is there. I have a 1992 Toyota Factory Repair...
  19. Replies
    33
    Views
    51,009

    Re: Help locating the starter relay

    Thanks for the replay man_btc, the photos definitely help explain my situation. I pulled my instrument cluster out and found two of the relays, but the green one that is for the starter is simply...
  20. Replies
    33
    Views
    51,009

    Re: Help locating the starter relay

    Sorry for bringing back this old thread, but I am having intermittent starting issues and was searching for the starter relay. I see that there's a consistent location across models/markets (manual...
  21. Replies
    30
    Views
    29,563

    Re: Wiper Blade Replacement 1991 Previa

    The ANCOs worked for months without issue. Then the Passenger side wiper blade, the actual rubber wiper portion, would shift within the track to the outer right side edge of the track. It would bunch...
  22. Replies
    2
    Views
    6,188

    Re: PIAA Wiper Refills for Front Wiper Blades?

    Here are some photos that I took this evening with the PIAA refills in the OEM wiper arms for my 1992 Previa.

    10584

    10585

    10586

    10587
  23. Replies
    30
    Views
    29,563

    Re: Wiper Blade Replacement 1991 Previa

    I replied to a thread I made for the PIAA Super Silicone wiper refill blades. I ordered some and installed them. Tight fit with the two metal strips that are common on newer design wiper refills.
    ...
  24. Replies
    2
    Views
    6,188

    Re: PIAA Wiper Refills for Front Wiper Blades?

    I went ahead and ordered the PIAA 28" Super Silicone Wiper refills, part number: 94070

    I previously bought the ANCO W-28Rs and they worked fairly well for some months, but I had to replace them...
  25. Re: Front End - '91 Previa LE AWD - Ball Joint, Tie Rod Ends, Sway Bar link & Bushing

    Thanks for providing information about your front end rebuild. I'm considering this for my 1992 Previa LE and was considering Proforged parts. What brand did you end up going with for the parts?
  26. Replies
    30
    Views
    29,563

    Re: Wiper Blade Replacement 1991 Previa

    I've gone over to the ANCO 4808 adapter, which allows the rear wiper arm to receive a traditional J-hook wiper blade. Works great for me thus far.
  27. Replies
    3
    Views
    6,506

    Re: going to synthetic oil?

    Yes, the Previa is really a great vehicle. Unfortunately, parts are phasing out for them. Maybe the aftermarket will fill in the void where Toyota has phased out parts? Aren't these much more popular...
  28. Replies
    30
    Views
    29,563

    Re: Wiper Blade Replacement 1991 Previa

    Yes, I noticed this as well. It is not linear, the tabs are wider on one end and narrower on the other.

    It rained today and I got to use the Ancos, they look to be a good alternative to the OEM...
  29. Replies
    1
    Views
    4,525

    Re: 94-99 wiper upgrade conversion

    This is an awesome solution that I was wondering about! Sure does make it easier for those with 1991 to 1993 Toyota Previas to swap over to a newer style wiper arm that accepts readily available...
  30. Replies
    30
    Views
    29,563

    Re: Wiper Blade Replacement 1991 Previa

    After filing down the plastic back on the Anco W-28R, they do indeed fit into the Previa's wiper arms without modifying/bending the tabs back.

    I just tested the Ancos out with the windshield...
  31. Replies
    30
    Views
    29,563

    Re: Wiper Blade Replacement 1991 Previa

    I just received my Anco W-28R refills and I see you said you had to bend the tabs because they got bent over the years, but I think that the Anco plastic body is just too large for the channel.

    I...
  32. Replies
    30
    Views
    29,563

    Re: Wiper Blade Replacement 1991 Previa

    Awesome solution with a follow up video to show the results! This no doubt helps a great deal for the future of owning/driving the Previa.

    I do have one concern though, it seems that these might...
  33. Replies
    30
    Views
    29,563

    Re: Wiper Blade Replacement 1991 Previa

    Thanks for the update. Apparently, Toyota has discontinued the front wiper blade refills, part number 85221-YZZB3-TM. I have contacted several Toyota dealerships and they are backordered with no ETA....
  34. Replies
    2
    Views
    6,188

    PIAA Wiper Refills for Front Wiper Blades?

    Hello,

    I know of several adapter solutions for the wiper blades on the Previa, but has anyone tried the PIAA wiper refills?

    http://www.piaa.com/store/c/72-Wiper-Refills.aspx

    I bought some...
  35. Re: How concerned should I be about the radiator cracking (pic included)

    By the way, I definitely used my Factory Repair Manual when changing out my radiator two months ago. It also has instructions for bleeding the coolant system out.
  36. Re: How concerned should I be about the radiator cracking (pic included)

    As for the comment regarding finding a Toyota Factory Repair Manual for the Previa, it is a must have. Many mechanics do not want to touch a Previa because they are afraid of dealing with the unknown...
  37. Re: Yahoo Previa Group Files available until 12/14/2019

    Much appreciated
  38. Re: Yahoo Previa Group Files available until 12/14/2019

    I'd personally appreciate someone taking the time to save the website. And I'm sure others would as well. It doesn't even matter the format or how disorganized it is. There's always the search...
  39. Re: How concerned should I be about the radiator cracking (pic included)

    Yes, you should definitely replace your radiator. That is a rather cheap item as mentioned above.

    What did you mean by plugging the transmission lines with a pencil? I do not understand what you...
  40. Re: Yahoo Previa Group Files available until 12/14/2019

    How do I get access? Seems when I click on the link in the PDF it tells me that you have to be a member? I just requested to join. Not sure if I'll get accepted before December when all content will...
  41. Replies
    2
    Views
    9,588

    Re: Previa transmissions, in general, run hot?

    Thanks for the reply. I was considering putting a bigger capacity transmission cooler on, but I will simply modify my driving for the situation. If it is too hot out, I'll simply keep the speeds...
  42. Replies
    2
    Views
    9,588

    Previa transmissions, in general, run hot?

    I have a 1992 Toyota Previa LE 2WD non-SC Automatic. It has over 400,000 miles on the original transmission. Engine swapped out for a JDM at around 389,xxx miles when the original was overheating.
    ...
  43. Thread: MPG and Previas

    by apham8
    Replies
    37
    Views
    52,925

    Re: MPG and Previas

    1992 Toyota Previa LE with a recently replaced engine. It is a low mileage JDM engine, although I do not know exactly how many miles.

    21.5 mpg with a good 50/50 mix of highway and city driving....
Results 1 to 43 of 44