Search:

Type: Posts; User: Burntboot; Keyword(s):

Page 1 of 10 1 2 3 4

Search: Search took 0.08 seconds.

  1. Replies
    68
    Views
    43,775

    Re: Cooling system Mods

    This thread is more about cooling systems than AC systems and there are about a thousand threads on AC issues.
    That said:

    The reality is that when new, these vans had no cooling issues, it is...
  2. Replies
    3
    Views
    289

    Re: Sliding window glass replacement

    Just go to "advanced search" (top right corner) and type in "Carbonized" in the user name search and hit enter.
    Its down near the bottom of the page (#30)
  3. Replies
    3
    Views
    289

    Re: Sliding window glass replacement

    The window frame assembly comes out as a unit, then gets disassembled

    Carbonized did a blog write-up on it

    Sliding windows rehab.
  4. Replies
    4
    Views
    560

    Re: New old Toyota 1988 YR22

    How did you "check" the seal?

    If hot engine compartment air is seeping into the cabin the seals are always the first suspect in the line up.
    A visual is not sufficient, put a pice of paper over...
  5. Replies
    3
    Views
    382

    Re: Rear Wiper Motor Not Working

    I don't know if you checked the correct wires or not.
    However there are several threads on rear wiper issues.
    Lots of problems with wiring, especially where the rubber bellows are, near the hinges....
  6. Replies
    3
    Views
    512

    Re: van hums randomly when warm

    It sounds like an over worked or tired pump.
    When was the last time the fuel filter was replaced?

    We used to have a Jag that would make a similar sound.
    Rust residue in the tank would slowly...
  7. Replies
    3
    Views
    512

    Re: van hums randomly when warm

    It's been my experience that when fuel pumps start to be heard in abnormal ways, its just their way saying "please replace me, before I leave you stranded"
  8. Replies
    6
    Views
    585

    Re: Engine only turns over in 1st gear?

    Strange indeed.
    There is nothing I am aware of, that would link gear position with ignition

    If it were me, I would be checking all the ground straps, I have seen cars do weird things when...
  9. Replies
    6
    Views
    585

    Re: Engine only turns over in 1st gear?

    I'm confused, in my world cranking and turning over are the same thing.

    Does it only crank(turn over) with the key turned and the trans in 1st or does it turn over(crank) all the time, but will...
  10. Replies
    8
    Views
    646

    Re: game plan for upcoming flush

    PD - if your referring to the article Gwen did on getting to know your coolant hoses, then yes, in that picture the tee is indeed on the heater output.
    It's also noted in the text that the Tee came...
  11. Replies
    8
    Views
    646

    Re: game plan for upcoming flush

    As for those sticky levers, try this thread:
    Thread: HVAC Climate Control Spider & Cable
  12. Replies
    8
    Views
    646

    Re: game plan for upcoming flush

    PD - Any name brand product is going to work for your flushing.
    No idea what the difference is between the 2 Prestone's, marketing perhaps??

    I am not familiar with water hammer products, other...
  13. Re: Bought a 1986 Van: Hoping for Help with Initial Diagnostics

    Unburnt fuel smells are bad, especially when you cant see a leak.
    You know what they say about assumptions.

    See this thread for what can happen
    Thread: Ebay Offering: '87 4WD
    Warning: The...
  14. Replies
    76
    Views
    36,592

    Re: Power steering system noise?

    If you aren't noticing significant difference in steering resistance with engine on or off you definitely have a problem with the power steering.
    No need to chase front end stuff, other than for...
  15. Replies
    76
    Views
    36,592

    Re: Power steering system noise?

    WT -Sorry to hear of your troubles.
    I am confused by a few things you stated:

    "I did notice at times when the van was idling the ps-pulley would seize up, so I decided to replace the pump...
  16. Replies
    2
    Views
    666

    Re: run rich only in open loop

    I think your assumption (of an electrical fault) is off the mark.
    (It shouldn't run like that, ever)

    To have that much fuel on start up, enough to cause smoking and shaking I would be looking at...
  17. Re: Liftgate / Rear hatch alignment frustrations

    Usually you can just line up the paint marks and call it a day.

    That said: The hinges are horizontally mounted so adjustment is fairly easy.
    Moving the hatch forward (toward the van) will close...
  18. Re: Oil Mysteriously Pooling behind driver's seat by battery compartment????

    That is very weird.

    Is it actually wet or is it a soaked in/dry stain?
    If still wet, can you smell anything from it?
    Are you using any fluids that would indicate a significant leak?

    What do...
  19. Re: Oil Mysteriously Pooling behind driver's seat by battery compartment????

    There isnt really anything that could leak there.
    First thought would be an old spill not cleaned up.
    But there is another possibility.

    The floor is covered in a sound deadening material that...
  20. Replies
    7
    Views
    956

    Re: Trying to diagnose rear wiper troubles

    So, if I understand correctly, with everything in place and the cover off the motor, it runs for a bit, then stalls and wont "restart", yes?
    If so, is this your basis for flagging the motor as the...
  21. Replies
    35
    Views
    14,090

    Re: Seat Belt questions

    And I hadn't checked your links, but they do look like a capable work around.
  22. Replies
    35
    Views
    14,090

    Re: Seat Belt questions

    My bad, forgot about those guys.
    You could probably make something work, but the factory ones are much more robust and I would hate to take a chance, given its purpose.

    A pick&pull would be your...
  23. Replies
    35
    Views
    14,090

    Re: Seat Belt questions

    If the vehicle already has the welded-in nuts, the best thing would be the proper bolt

    Seatbelt bolts are different threads so as to not get mixed up with regular bolts, that being said, they are...
  24. Replies
    7
    Views
    956

    Re: Trying to diagnose rear wiper troubles

    I have a rear hatch door that came off a JDM van, but an earlier version no doubt.

    11077

    The motor assembly bolts to the door, and is comprised of 2 subassemblies, the electrical side with the...
  25. Replies
    7
    Views
    956

    Re: Trying to diagnose rear wiper troubles

    Not sure how similar your van is compared to the NA model, but maybe check this thread Rear wiper motor problems!Carbonized provided pictures that may well help. (post #15)

    You will need to check...
  26. Re: Help Need a workaround for an NLA Overdrive relay

    Realized after posting that my reply was unhelpful, as I misread the problem, then couldn't find the "delete post" button.

    Is there something special about that relay.

    If memory serves, the...
  27. Re: Help Need a workaround for an NLA Overdrive relay

    deleted
  28. Replies
    3
    Views
    898

    Re: "Pop" noise when making sharp U Turn

    CV's would only be in play if you were in 4WD and I am assuming you wouldn't do that on dry pavement.

    There is nothing inherent to vans to create that particular situation that I know of.
    Without...
  29. Replies
    2
    Views
    838

    Re: Remanufactured brake master

    I haven't held a van master in some time, but I wouldn't worry about what your seeing there.

    That is only the casting you are looking at.
    The piston is the green thing behind the black circlip....
  30. Replies
    33
    Views
    7,464

    Re: no brakes at all

    Even if the rear wheel cylinders were seized it wouldn't create your current issue.
    I haven't used a vacuum gauge in years so can't advise there but there are ways to assess the integrity of the...
  31. Replies
    33
    Views
    7,464

    Re: no brakes at all

    Boosters are not a known problem area and I wouldn't go changing one unless I was damn sure mine was faulty (horrid job to do)

    Generally speaking, when a problem develops shortly after installing...
  32. Replies
    33
    Views
    7,464

    Re: no brakes at all

    "I replaced the master and front calipers about 6 months ago and they were working fine after bleeding a few times. Now, the peddle is very hard and they work badly."

    Are you saying the problem...
  33. Re: van doesn't start, with turn of key there's no cranking, clicking it's silent

    12.2V would be considered fully discharged, so probably start with a new battery and go from there.

    Out of curiosity, how did you "check" the fusible links?
    (A visual is not sufficient.)

    No...
  34. Replies
    4
    Views
    940

    Re: 1989 van wagon wiper linkage

    Its been my experience that when wipers go "out of sync" the linkages are usually still okay, the fact that it works sometimes would indicate the linkage is moving, even if the sockets are sloppy,...
  35. Replies
    8
    Views
    1,547

    Re: Exhaust leaking into car

    Sorry, I wasn't clear.
    Several threads on exhaust manifolds and their tendency to crack and leak, same for EGR system problems.
    The whole exhaust system needs to be sound.

    The hood is the thing...
  36. Replies
    8
    Views
    1,547

    Re: Exhaust leaking into car

    This is only a new problem for you, it has been covered in many threads, over the years, doing a search will answer all your questions.
    In the meantime, exhaust leaking into the cab can only happen...
  37. Re: Inconsistent Idle - Beck Arnley TPS Heads Up!

    PCV hose needs to be rated for both oil/fuel resistant and vacuum capable (reinforced).
    Heater hose is neither of those things and will cause problems.
  38. Replies
    2
    Views
    1,247

    Re: Removing rear shocks

    There is actually a special tool for that job.
    Its a socket that fits perfectly over the ovalish' bit above the threads.

    That said, a small pair of vice grips should prove worthy.
    Some (most?)...
  39. Re: 1989 4x4 LE Camper in Ashland, Oregon / Parts van?

    Might be worth getting a 2nd opinion on the terminal diagnosis.

    I say that simply because the cylinders are not "sleeved" as quoted and Toyota blocks are not known for cracking.

    BB
  40. Re: Valve Stem Seals On Vehicle Replacement w/o removing the head

    I've done it (not on a van mind you, but the procedure is the same)

    Remove a spark plug and with the piston 1/2 way up, feed a nice (long) soft rope into the spark plug hole.
    Make sure you leave...
  41. Replies
    64
    Views
    34,066

    Re: Drive shafts and u-joints

    85 van are 2WD only, as such they do not have a "front driveshaft", perhaps the front joint failed on the rear shaft??
    The only way I could imagine a pop top coming off at speed is if it wasn't...
  42. Replies
    22
    Views
    3,738

    Re: Idle rpm in gear too low

    I've never known a vacuum leak that could cause a low idle.
    Ahigh idle, sure, most of the time, but a big leak, that usually induces a stall.
    I've never known a big leak to create a low idle, that...
  43. Replies
    22
    Views
    3,738

    Re: Idle rpm in gear too low

    I know very little about the internal workings of an auto trans, but don't believe convertor failures are common, at least not on 80's technology.
    I would have thought that if the torque convertor...
  44. Replies
    22
    Views
    3,738

    Re: Idle rpm in gear too low

    Out of curiosity, how does it run outside of the idle issue, any stumbles or lack of power or bad mileage, noisy &/or smelly exhaust......

    Assuming that tune up stuff is all up to date (especially...
  45. Replies
    22
    Views
    3,738

    Re: Idle rpm in gear too low

    How long have you had it and how long has it been acting up?
    Have you done any standard maintenance (plugs, filters..., compression test.....) since you've owned it?
  46. Replies
    22
    Views
    3,738

    Re: Idle rpm in gear too low

    When you start the vehicle and the instrument pack does its self check, does the check engine light come on then?
    Maybe try inducing a code, just to make sure the management end of things is working.
  47. Replies
    22
    Views
    3,738

    Re: Idle rpm in gear too low

    Have you checked for stored codes?
  48. Replies
    36
    Views
    13,549

    Re: clutch master and slave cylinders

    Well, not bench bleeding the master prior to install will indeed save you like 5 or even 10 mins!

    But here's the rub.
    When a master is built (or rebuilt) there will be air trapped in the...
  49. Replies
    6
    Views
    1,590

    Re: Is front body panel removable?

    Not removable
  50. Replies
    12
    Views
    2,617

    Re: Bad Coolant Leak + Overheating

    The tool that Original quoted will do the job.
    I use an old skinny screwdriver (not a sharp edge on the thing) also have one with a bend in it.
    Slide between the fitting and the hose and gently...
Results 1 to 50 of 500
Page 1 of 10 1 2 3 4