Search:

Type: Posts; User: chugach; Keyword(s):

Search: Search took 0.01 seconds.

  1. How do I remove front right axle on 94 alltrac

    My front right wheel bearing is bad and when I was sliding the CV axle around I notice a lot of play where the inner CV bolts to the axle tube. Is there a bearing right inside there? How do get it...
  2. Changed Transmission Filter, gasket and ATF and now my transmission sounds different?

    So the gasket was leaking and Im sure the ATF was pretty old. Yesterday I drained the pan, replaced the filter and renewed the gasket. I filled it with DEx/ Mercon ATF. This moring when i started it...
  3. Van runs for about twenty seconds and shuts off, fuel pump?

    So van has been sitting all summer then i took it out today after putting a new axle in. It ran for about 45 minutes, then sputtered out. I thought it was low on fuel or water in the fuel from...
  4. Replies
    9
    Views
    6,520

    Re: Recommendation for reman Previa engine.

    There is a great thread on here I think by timsrv of how he did it that you should read it has great photos. I think it was called twist on engine removal.It may have been someone else, anyway all I...
  5. Replies
    3
    Views
    6,256

    Re: Considering Infamous JDM Engine Swap

    I bought an eBay jdm a few years ago. It runs perfect and I have put maybe 15,000 on it. I had it shipped to Alaska where I live and although it had a warranty, if I had a problem there's no sending...
  6. Replies
    9
    Views
    6,520

    Re: Recommendation for reman Previa engine.

    I bought a jdm from a company in California after I destroyed my engine by driving in too deep of water. I paid a lot to ship it to Alaska where I live. It really was not as hard to get out as I had...
  7. Re: Will rear axles from non super charge awd fit on newer super charge awd

    What about just the axle shaft not the diff. Will an axle shaft from a non awd work in an awd. I have a bent axle shaft and trying to find an awd specific one is pretty difficult.
  8. Re: Recommendations for removing rear wheel bearing that will not move?

    Thanks for the above suggestions. As far as pounding some rebar through, it doesnt work that way. The axle would not come out so there is no where to send it through. The axle and bearing come out...
  9. Will rear axles from non super charge awd fit on newer super charge awd

    Thats the question, will rear axles from an earlier non supercharged all trac fit on a later supercharged alltrac. and is the rear diff the same? could i take the entire axle assembly from the older...
  10. Recommendations for removing rear wheel bearing that will not move?

    rear wheel bearing has been grinding for over a year and cant get it out. i just took it to a mechanic and he broke every tool he had trying to get it out. I think i might chain the axle to my truck...
  11. Pick and pull yards online inventory site, has anyone used this?

    I just found this site today. row52.com. it inventories all the participating self service yards. people can go on there and ask for a part and someone will go and get it for you. i live in alaska...
  12. Re: Intermittent Starting Problems & Check Engine Light!!! '91 Previa LE AWD

    Hey Tim , is there a way to test the fuel pump relay, I don't have access to a junk yard for a different one. I ran a jumper to the two contacts you mentioned and my pump ran fine. I put my tank and...
  13. Replies
    3
    Views
    4,355

    Re: My full LED upgrade (exterior & interior)

    Yeah where did you get all the bulbs. Also what are you using for flooring in there?
  14. Replies
    29
    Views
    24,044

    Re: jdm engine installed but running poorly!

    I forgot to follow up on this since its been a long time but the problem was a cracked super charger. from water getting into it and freezing.
  15. Replies
    2
    Views
    3,416

    exhaust parts for 94 supercharged engine

    hello, my exhaust was rusted out and i bought a system from rock auto. i was very excited to see all this new shiny metal to put. i bolted the converter to the manifold then i installed the muffler....
  16. Replies
    2
    Views
    3,741

    Rear wheel bearing and axle removal

    So i believe my rear driver wheel bearing is going out. Vibrating and my whole wheel gets hot to the touch. Ordered all the parts from rock auto. pulled the driver side axle, it was difficult but it...
  17. Re: Front strut coilover project to allow taller tires

    would this work, http://www.ebay.com/itm/JDM-Toyota-Previa-Estima-TCR10-TCR11-Kouki-Racing-Coilovers-Springs-/361460376047?hash=item5428b7a1ef:g:BoAAAOSwT~9Wh0WK&vxp=mtr
  18. Replies
    29
    Views
    24,044

    Re: jdm engine installed but running poorly!

    So I gave up trying to figure it out on my own and took it to a mechanic. He has only put two hours into it but says there is no vac leak. He had it running on propane and said it ran fine and that...
  19. Replies
    29
    Views
    24,044

    Re: jdm engine installed but running poorly!

    I get home in a week and I will post another video of it running while I hold down the throttle. If I hold it down it will stutter and then catch up at higher rpm but as soon as I let go it will die...
  20. Replies
    29
    Views
    24,044

    Re: jdm engine installed but running poorly!

    Disconnected tps and nothing changed.
  21. Replies
    29
    Views
    24,044

    Re: jdm engine installed but running poorly!

    My user name is Jason wilsin . Clip is called previa jdm install need advice
    http://m.youtube.com/watch?v=ShiAEKLFexE
  22. Replies
    29
    Views
    24,044

    Re: jdm engine installed but running poorly!

    OK I made a short video clip of what the new engine is doinghttp:// https://www.youtube.com/watch?v=ShiAEKLFexE&feature=youtube_gdata_player. If that does not work try searching previa jdm install
  23. Thread: vacuum lines??

    by chugach
    Replies
    1
    Views
    3,050

    vacuum lines??

    Does anyone know the different diameter vacuum lines I would need to order to replace all the existing lines on a 94 sc. Hoping that replacing the lines will solve my current problems.
  24. Replies
    29
    Views
    24,044

    Re: jdm engine installed but running poorly!

    ok for now im assuming that i truly have an s/c engine. when i get home im going to replace all the vacuum lines. does anyone know the sizes of these lines. im ordering rolls of vacuum line from a...
  25. Replies
    29
    Views
    24,044

    Re: jdm engine installed but running poorly!

    Are you kidding me? Is there a way to tell sc or na by looking at the block? I'm away from home for three weeks working so I can't recheck my invoice until I get home. I ordered it from engine world...
  26. Replies
    29
    Views
    24,044

    Re: jdm engine installed but running poorly!

    My invoice says 2tzfe supercharged so hopefully its the right one.if not I will completely give up. So you are leaning towards vacuum leaks. Like I mentioned the little plastic hose that goes into...
  27. Replies
    29
    Views
    24,044

    Re: jdm engine installed but running poorly!

    There are a lot of vacumm lines how do I track it down if it is that. Also I ordered a s/c engine how do I confirm that it really is? It had the same letters on the block and everything seemed the...
  28. Replies
    29
    Views
    24,044

    jdm engine installed but running poorly!

    So I just spent the last five days taking out my old engine and installing a jdm. I got everything back together today. Filled all fluids and started it up. Here is what it does. Starts right up,...
  29. Replies
    33
    Views
    63,869

    Re: A twist on Previa engine removal

    so if i get my previa that high in the air and i get a jdm engine, what parts should i change out while i have the oppourtunity.
  30. Replies
    33
    Views
    63,869

    Re: A twist on Previa engine removal

    I will be attempting this soon. I was wondering if you think its possible to do it without the lifting table and perhaps a good floor jack inside the van as you did it. or even a chain hoist to lower...
Results 1 to 30 of 34