Hi I used these
https://www.ebay.com/itm/204339838022
Type: Posts; User: Diy2k; Keyword(s):
Hi I used these
https://www.ebay.com/itm/204339838022
DONT FORGET TO CHANGE THE TRANSMISSION MOUNT!
Thanks Timberland
The link Timberland posted show cheaper OD solenoids
It’s the Volvo 240 OD valve. If you google it you’ll see it’s very similar to the one we have.
The old OD needs to be sliced into the wiring since it does not share the same plug.
...
I’m going to have a try at some chips later this month. I’ll send some pics with the process I’ll use.
Wheels off a 1986 Toyota van. Come with 185/70r14 and 195/70r14 tires. They are straight and tires are good.
These are originally from a Nissan but work with our vans.
50$ obo
...
Toyotavantech: Noooo you can’t lift the engine too much
DIY mechanics: hahah jack go Uga Duga
Yo!
Don’t be afraid to use your jack on the engine. Lift the engine up a few inches and it will give way to the pan.
Also don’t forget the frame stiffeners.
Higher idle , or the lockdown cable is not adjusted correctly.
if you’re idle has t been touched look for a crack or leak in intake boot.
The struts are new. I’m going to swap the ball joints next go. Maybe sagging torsion bars ?
Dang
I’m getting sag up front on my 2wd and wondered if 2” spacers would help.
Buenas, yo puedo preguntar en ingles.
Can someone send this man a copy of the owners manual?
Doesn’t sound crazy. The seals alone should make a big enough difference. Just make sure the valves are seating properly and the seals are new.
Macd, what side for the rear seat belt cover ?
Hey
I was about to rebuild these injectors when I decided to upgrade. They have a general Exterior clean and they all click with a 9v attached.
Located in LB,CA. I can ship but it’s going to...
Depending on the year , you can get a new 3y or 4y engine. They still make them for industrial use , so it shouldn’t be hard to find a new block.
If you get them at a local auto parts store just ask them to match the cylinders. These cylinders usually come with a generic factory number that can be matched to other cylinders.
Is it possible to throw out the timing when installing the starter? I just rebuilt mine, and after installing it the TV runs off. Easy on but sputters under acceleration. I also get backfire in the...
Check the Rotor and cap as well. Sometimes water seeps in from a drain hole below and causes the engine to act up.
Came here to say that is beautiful. Have you checked the Toyota and the Chilton manual?
Does it crank or is it a click when trying ?
Reserve-pump hose doesn’t need to be anything fancy since it holds no pressure.
Is it lose at the terminal or on the wire?
These things are like gold at junkyards.
I’ll look for one in SoCal when another van pops up.
Awesome Javi!
Not to break your heart but this is an option as well.
...
Post frame mount celebration
https://ibb.co/zQWfM1q
Woah , just asking.
If any of you are in Los Angeles I would love to come over and peek at how you guys replace the bearings.
Are you sure it’s not covered ? Mine had the cap on really tight and I thought it didn’t come with hose fuses.
So....
What’s the review on 2wd ball joint spacers ?
Hey guys!
I’ve been calling and doing nothing but research on the CAT for the past two weeks. I did happen to find one that is approved and cheap. On top of that it’s from Autozone so they...
I was wondering about those injectors as well. I’ve inspected my injectors (exterior) and they look almost done.
Hey!
Have you tried making a lift bracket for the LSP? It’s a small bracket intended to lift the valve up and allow the brakes to work correctly. It made a difference on my van after I lifted...
Where is the van located ?
Can’t see the image
Guess who has high P/N idle after rebuild!
*me*
Pulled the shocks from an 89 2wd and 2000 Durango at the junkyard. Kyb shocks are from the Durango and look to be the same size base size as the stock Toyota shocks. Lengthwise is the difference.
...
https://www.amazon.com/MagnaFlow-447206-Universal-Catalytic-Converter/dp/B007C800XU
How about this one?
On the same boat. Ordered an 02 sensor , tps sensor, egr gasket,Air filter,and plan on cleaning the TB. If all else fails I’ll get the CAT cut off and have a universal one welded. The Magnaflow is...
All from a 87 4x4
- Dome lamp
-left speaker cover
- right seatbelt cover
Located in LBC,CA
Contact me via here for pickup or shipping