Can I put spacers without replacing the wheel studs? :cnfsd:
Type: Posts; User: Estima; Keyword(s):
Can I put spacers without replacing the wheel studs? :cnfsd:
Any suggestions?:cnfsd:
If anyone has this setup, can you please let me know what you did for your setup? Thanks! :)
I tried it, but it rubs the stabilier bar. :?:
Argh! I spoke too asoon. Now my problem is the brake line #8 (line from the master cylinder) to the front driver side brake hose. Part#: 4731828010.
I'll try to visit the junkyard, to see if I can...
I tried pulling the caliper and the slider pin slides fine...but I guess it needs de-greasing (who know when it was last looked at :cnfsd:)..
What good silicone grease can you recommend?
Hi all,
I just finished the front passenger (struts, rotor, and brake hose) and bled the brakes. Tested the brakes (drove back & forth and around the block)and went fine. Went over the driver...
Thanks everyone. Ended up going to the junkyard & pull a good set of brakes lines....
Ahh the growing pains of having a 2 decade old vehicle :wnk:
Sorry "ff" means following :lol:
Anyway, when you say drain the Master cylinder, it's the one that you put brake fluid in, right?? If that's the case, "AIR" will be in the system and it would be a...
I was able to pull one from pick-n-pull yesterday from a 92 (I think they're all the same) :dance2: but the driver side is tight as hell and ended up getting the passenger side. I just have to clean...
Hi folks,
I'm in the process of replacing front passenger brake hose, struts, brake pads, rotors...
The steps I did so far:
1. Jacked up the van, removed wheels
2. Loosening the steel brake...
Got pics?? how much did it cost you?? with shipping?? :?:
Go with coilovers if you intend to lower your Previa. Ebay's the place. :rol: