Hi All,

In an effort to replace the sliding door handle on my 96 previa, I've had quite a bit of trouble in swapping the lockset from the old handle to the new one. I removed the silver U-shaped clip in the photo below (I took the photo before I removed it).

wh2.jpgWhatsApp Image 2025-11-01 at 14.21.51_2b7e13c3.jpg
I couldn't find any other instructions in the Haynes manual or online, just "remove retaining clip and then remove the lockset".
It seemed very stuck in the old door handle. I did finally shimmy it out, but now the key won't function in the lock, and I fear I've broken it. I may consult a locksmith to take a look at the lockset. So a couple of questions -

1) Is there a step I'm missing in removing the lockset from the handle?

2) If I did in fact break the lockset, do folks have any info on sourcing a new one?

Thanks!