There is no content in this section
I am still waiting for a coil spring insulator that is hung up in Dubai, otherwise I could finish this way-too-long front end thread this week. I received everything else I need today-left side tie...
Just to be clear, this is what I did with the lower roller. Its potable water PEX, smaller than 1", the OD is about 22 mm ID about 17mm... 13384 Don't ask me about the bent track, because...
Here is a recent thread with some cylinder head info. https://www.toyotavantech.com/forum/showthread.php?8822-Replacing-head-1992-2TZ-FE-The-Saga-of-Njordi I am in the same position with a...
Hi Everyone The engine has bee removed for a second time. A cracked cylinder head block has been identified - nightmare scenario! I can imagine that a replacement cylinder head is not easy to...
I think "CV" might mean a Toyota Camry or Vista with a 2CT. If so, the plunger stroke on a van should be 0.77 - 0.83mm. 13380
Section Widget
Categories Widget (Show All)
Recent Forum Posts
Re: my front end thread
I am still waiting for a coil spring insulator that is hung up in Dubai, otherwise I could finish this way-too-long front end thread this week. I received everything else I need today-left side tie...
Previologist 07-02-2025, 07:20 PM