update:
after disconnecting the ecu, i found that there is less than half an ohm resistance from one end of the single-wire knock sensor harness to the other end (good), and that the wire is an...
Type: Posts; User: silverbox; Keyword(s):
update:
after disconnecting the ecu, i found that there is less than half an ohm resistance from one end of the single-wire knock sensor harness to the other end (good), and that the wire is an...
THANK YOU! i was stuck in the mobile version on this laptop, using firefox. no idea why. i've never used a cellphone to look at the site before. so much better now.
yes it is connected to the ecu, i haven't actually measured it with the ecu disconnected, which would be a good idea. i imagined that this many ohms might be a feasible resistance to build into the...
i installed the new knock sensor (again, without cutting the floor or moving the engine) and then i cleared codes and drove a tiny bit before getting another code 52. so i will try to find a...
i am troubleshooting a check engine code #52, which is "knock control - malfunction" according to the internet or "no knock sensor signal" according to a chilton manual.
i removed the knock...
i actually really like the idea of having a boost-ready engine in my van, but it is a very low priority right now compared to my need for this expensive repair to work well the first time. this has...
i'm not worried about transmissions because that was a matter of handling extra torque from supercharging. i'm talking about running the SC motor without boost, just swapping it in without the...
wow thank you for going to the trouble of digging up all that information. super cool. i have an update, the importer really doesn't know whether or not i got an FZE because they ship them out ...
man i would really love it if someone knew the details about this.
so the situation is getting all dramatic because the engine arrived at the shop, with a tag on it that said "2TZ-FZE". i had the...
i bought the engine today and i'll try to post up when the job is finished, to let you guys know how compatible things ended up being. i'm sure the long block will be fine, but the peripherals might...
what are the differences between the 91-93 and 94-95 2TZ-FE engines?
i'm going to buy a JDM engine for my 1991 previa and there is a naturally aspirated version available, listed as a 1994-95...