I am doing an wheel to wheel overhaul of spare 4wd rear drive assembly. I am considering a locker for the rear. Any opinions on which brand is preferred with these 7.5" differentials? I have plans...
Type: Posts; User: EZHIKER; Keyword(s):
I am doing an wheel to wheel overhaul of spare 4wd rear drive assembly. I am considering a locker for the rear. Any opinions on which brand is preferred with these 7.5" differentials? I have plans...
Hoping for a glove box?
Thanks
Sam
Does anybody remember which rear Tacoma Shocks works best with the Mr. Gasket spacers? Or maybe point me to the thread?
Thanks
What is the going rate to have Fuel Injectors Rebuilt? Does anybody want to offer a recommendation? The other engine that will get attention was trouble free with 190K on it when it was pulled....
Thanks for the input on the TPS. The symptoms appear quite similar you your clogged injector. Everything worked fine until it didn't. I am going to monitor it over the next tank or two of fuel, maybe...
My 5-spd 4wd van is sick. I am suffering similar symptoms. I have a bad miss in the upper 1/3 of the rpm zone, it seems more pronounced when climbing a grade. I was thinking TPS as a starting point,...
Remove your glove box, and then then the relay cluster behind it. The resistor pack is lower left of the blower motor in the air plenum, usually a white plug, 2 screws holding in the resistor pack....
I am thinking KYB KG 5458 is the correct item. Any confirmation would be appreciated.
I have lost my notes and I am ready to upgrade my front shocks.
Does anybody know the Parts #, or year for the KYB DURANGO front shocks that fit on 4wd TV's?
Thanks
Sam
https://www.discounttoyotaparts.net/toyotaoemparts.html
http://www.toyotapartszone.com/oem/toyota~solenoid~assy~transmission~85420-28020.html
My kickdown cable broke. I remember sourcing a new OEM cable for around $225. The I did some general searches using the Toyota Parts # and found one for $75 (new). I'LL replace it when the trans...
I have experienced those symptoms. Issue was resolved by replacing the rusted fusible link near the battery.
After 20+ years Crusty old seized up tie rods are the norm. It may take a couple of days of penetrating lube soaking the threads and a large breaker bar to make them adjustable or just to remove for...
I recently replaced a valve cover gasket on one of my rigs. It definitely took longer than expected. If you go that route plan on replacing the (3) valve cover grommets and possibly the PCV grommet...
Sure sounds like a BHG
I was prepared to try another distributor/coil (next) as I did not think an ignitor could go south without complete failure. I Just finished the 1st leg of a road trip (600 miles), the van was...
My 4wd auto is running better than ever. The ignitor was not working properly. Swapped it out and saw immediate improvement. I also, replaced the crappy autolite plugs with mismatched gaps with...
You may need an pneumatic impact wrench to break the bolts. If your van is already sagging both shocks and cushions (upper and lower) should probably be replaced before cranking your torsion bars to...
How old are the shock cushions?
I have been having sporadic symptoms for months now. Van would run flawlessly most of the time and occasionally would have loss of power, a bit of a stumble and then normal power through the power...
I recently found this LT tire in the correct size. I'm considering a set because of the moderate off road like tread pattern
http://www.falkentire.com/Tires/Radial-A-P-8
This is a H725 High...
I just came across a bad dash blower switch on my latest project. Low did not work, the other 3 speed were fine. My resistor pack was replaced first and still no low. Swapped in another blower switch...