Quote Originally Posted by Burntboot View Post
I replaced my oil pan with the engine in situ, being that your's is a 2WD, I would think it would be a walk in the park to swap out, by comparison.
I used FIPG and was happy with the results, didn't have any significant issues getting the pan back into place.

Personally, I have no love of cork gaskets.
They are far too easy to over-tighten and they not fond of excessive heat.
BB
PS - I put the FIPG on the pan, before getting it anywhere near the vehicle, it has a long tack time, not at all like typical silicone sealants.
I attempted this yesterday and could not fully remove the oil pan because of the oil pump. Just a heads up to others! Not sure if it’s an ‘89 thing, the height my engine is at, or what, but what a wonderful surprise lol