Thanks Tim! This is helpful. I'm no longer hearing clicks after inserting/removing the jumper from the FPCC. Strangely, I'm only getting 6V out of the blue wire from the COR, but 12V is at the fuel pump connector at the gas tank (shown in image above). I'll double check the voltage again coming off the blue wire tomorrow to confirm that it's 6V. Not sure if relevant but I also have no voltage at the FPCC when I put the multimeter in that connection I get nothing.

As for the AFM - is there a way to confirm that I have a stuck closed switch in the AFM? Don't know much about the AFM so I'll do some digging around here in the meantime.

Appreciate your input