I've also started this conversion. I've got a 94' AllTrac and realized just yesterday that I'd need to trim out some metal to get these to bolt in. Did you have to drill a hole in the top to mount the side of the headlight closest to the grill?

And for the trim piece that goes between the bumper and the lights, how did you mount that on the bottom. The tabs it looks like it should bolt to are just about a half an inch off. Also, the turn signals, they don't look like they mount the same way at all and it looks like just two screws hold it in. Is that correct or is there any cutting required for those as well.

Thanks in advance for the info. I've searched high and low and haven't been able to find a definitive answer.