There is no content in this section
I am still waiting for a coil spring insulator that is hung up in Dubai, otherwise I could finish this way-too-long front end thread this week. I received everything else I need today-left side tie...
Previologist 07-02-2025, 07:20 PMJust to be clear, this is what I did with the lower roller. Its potable water PEX, smaller than 1", the OD is about 22 mm ID about 17mm...
13384
Don't ask me about the bent track, because...
Here is a recent thread with some cylinder head info.
https://www.toyotavantech.com/forum/showthread.php?8822-Replacing-head-1992-2TZ-FE-The-Saga-of-Njordi
I am in the same position with a...
Hi Everyone
The engine has bee removed for a second time. A cracked cylinder head block has been identified - nightmare scenario!
I can imagine that a replacement cylinder head is not easy to...
Re: Toyota Previa 1993 Smokey Exhaust
I have my head from CHI back on the van. I need to finish buttoning everything up, but I am pleased with CHI. I am pulling together a full technical bulletin for replacing the head gasket using...
Boerderij_Kabouter 07-03-2025, 09:16 AM