• man_btc

    There is no available content written by man_btc
  • Recent Article Comments Widget

  • Recent Forum Posts

    Previologist

    Re: my front end thread

    I am still waiting for a coil spring insulator that is hung up in Dubai, otherwise I could finish this way-too-long front end thread this week. I received everything else I need today-left side tie...

    Previologist 07-02-2025, 07:20 PM Go to last post
    Previologist

    Re: i have the all time sliding door cure for you

    Just to be clear, this is what I did with the lower roller. Its potable water PEX, smaller than 1", the OD is about 22 mm ID about 17mm...


    13384


    Don't ask me about the bent track, because...

    Previologist 07-02-2025, 07:00 PM Go to last post
    Jonny

    Re: Toyota Previa 1993 Smokey Exhaust

    Here is a recent thread with some cylinder head info.

    https://www.toyotavantech.com/forum/showthread.php?8822-Replacing-head-1992-2TZ-FE-The-Saga-of-Njordi

    I am in the same position with a...

    Jonny 07-02-2025, 03:54 PM Go to last post
    gjr5088

    Re: Toyota Previa 1993 Smokey Exhaust

    Hi Everyone

    The engine has bee removed for a second time. A cracked cylinder head block has been identified - nightmare scenario!

    I can imagine that a replacement cylinder head is not easy to...

    gjr5088 07-02-2025, 02:07 AM Go to last post
    89MasterAce

    Re: Adjusting Diesel Injection Pump Timing

    I think "CV" might mean a Toyota Camry or Vista with a 2CT. If so, the plunger stroke on a van should be 0.77 - 0.83mm.
    13380

    89MasterAce 07-01-2025, 04:28 PM Go to last post