Error Code 6 , 1987 Toyota panel van

[vintagecoffeeroaster]

Hello Everyone 👋

Does anyone have any experience with Error Code 6?

thank you in advance!

[89van]

Not too sure what you mean by error code 6, here's a manual of the diagnostic codes for elaboration:

https://www.toyotavantech.com/forum/...gons-all-years

Hope this helps!

[vintagecoffeeroaster]

Thank you. Yes I followed the diagnostic guide and code 6 is what came up, (no NE signal to ECM). I use the manual to attempt to diagnose the issue. When I checked the ECM, I found that I had a voltage reading of 2.2 volts between the corresponding terminals. The manual indicates that the voltage should be between 0.7 to 1.4 volts. I went ahead and ordered a new ECM.

The van will start but in order to keep it running I need to keep the rpm above 1500.

I checked all the visible connections and they all look ok.

if anyone else has any experience with code 6 I’ll take suggestions.

[vintagecoffeeroaster]

It was just a broken hose ok tht back of the air box… lol