Good news! Alignment is done and van is within specs! I took the van into Les Schwab for an alignment today & was lucky enough to get a seasoned tech. He tried several things to get the alignment to fall within specs (camber being the problem). Finally after all else failed, he put 1/2-13 grade 8 bolts into the upper position on the lower strut mount (original bolt was almost double that diameter). Then with both nuts loose, and full weight of van resting on tires (tires being on the sliding pads), he tightened these mount bolts back up. When checking the camber after that, he found the passenger side was dead on, and the driver's side was at .7 off. Out of curiosity I jumped in the driver's seat and had him check it again. With my weight on the driver's side, this brought both sides to .2 off (well within specs)! I needed to run some errands afterward and drove the van about 50 miles. I am very happy with the ride and it goes down the road nice and straight. After going through this, I can say with confidence that 2" lift is the maximum a Previa can be raised in this manner (without other complications). I am definitely glad I did this and I'm enjoying this van much more than before. Here are a couple of pics of the PS side lower strut mount with the smaller bolts in the upper position. Tim